Outback-power-systems MATE2 System Controller and Display Installation a Uživatelský manuál stáhnout pdf (Strana 65)

NOTE:HBXModewillcontroltheMasterFXSeriesInverter/ChargerinPort1ofaHUB-4

orHUB-10.eMasterwilltheninstructanystackedSlavestoUSEorDROPtheACinput

source(pleaseseeappropriatetheFXprogrammingmanualforstackinginstructions).

BeforestartingHBXMode,setorresettheestablishedvaluesonthefourMATEsetpoint

modes shown on the following screens:

• erstscreen,HBX-USEGRIDSETPOINTappearswhentheHBXsokeyispressedon

thepreviousADV/MATEscreen.

• Eachsuccessivescreenappearsbypressingthe<DOWN> key on the previous menu.

• Withthesescreens,theusersetsthebatteryvoltagesandtheamountoftimethesevoltages

must remain in order for the grid-supplied AC power to both recharge the battery and to

disconnect.Sincepowerdemandsurgescanbrieyaectabattery’svoltagelevel,establish-

ing voltage and time limits can prevent a premature or inappropriate connection to grid-sup-

plied AC power that can occur due to a momentary change.

HBX-Use Grid Set Point

isisthevoltagesetpointthatallowstheFXto

connectto(USE)ACpower.ebatteryvolt-

age must remain below the voltage listed on the

screen—24.0vdcinthiscase—fortheamount

oftimeprogrammedbytheHBX-USEGRID

DELAY(seenextscreen)beforeaUSEcommand

isissued.Usethe<INC> and <DEC> so keys to

change the voltage set point. Press the <DOWN>

sokeytoproceedtothenextscreen.

issetpoint—01.0hrsinthisexample—isthe

amount of time the battery voltage must remain

belowtheHBX-USEGRIDSETPOINT(above)

beforeaUSEcommandissent.Itcanrangefrom

00.1hrsto24.0hrsin0.1hourincrements.Times

are adjusted using the <INC> and <DEC> so

keys. Press the <DOWN> so key to proceed to

thenextscreen.

HBX-Use Grid Delay

ADV/MATE/HBX--------------------

hbx-use 24.0 vdc

grid setpoint

DOWN ADV INC DEC

ADV/MATE/HBX----------------------

hbx-use 01.0 hrs

grid delay

DOWN UP INC DEC

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 131 132

Žádné komentáře

Outback-power-systems MATE2 System Controller and Display Installation a Uživatelský manuál Strana 65