Outback-power-systems MATE2 System Controller and Display Installation a Uživatelský manuál stáhnout pdf (Strana 56)

NOTE:EQ(EQUALIZE)isnotanautomatic

partoftheFX’schargecycle.WiththeACinput

alreadyconnectedtotheFXsystem,anEQcharge

must be manually started from this menu. e

EQcycleendsaerthetimeittakestochargethe

batteriestotheEQvoltageandtheEQtimelimit

orbymanuallystoppingtheEQchargefromthis

menu.

Pressing <EQ>ontheCHARGERMODE

CONTROLscreenbringsuptheEQUALIZE

CONTROLscreen

When <STOP>hasbeenselected,theEQcharge

has stopped.

When <START> has been selected, two

informational screens are displayed. e user

must push the <MORE> so key before an

equalizingcyclecanbegin.

EQUALIZE CONTROL

eq enabled

START STOP OK

NOTE:Startthegeneratororcheckthatthegrid

isconnectedbeforestartinganEQcycle.eAC

INstatusLEDontheFXmustbesolidyellow.

eEQENABLEDscreenallowsanequalize

chargingcycleoranexit.Pressthe<YES> so key

to enable and then press <EXIT>.

EQ parameters must be set in

ADV/FX menu. follow manuf.

recommendations

For EQ settings ac source must be

connected to start EQ cycle

EQ ENABLED: No

are you sure you wish to start an

EQ cycle?

YES EXIT

EQUALIZE CONTROL

eq charge stopped

OK MAIN

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 131 132

Žádné komentáře

Outback-power-systems MATE2 System Controller and Display Installation a Uživatelský manuál Strana 56