Outback-power-systems MATE2 System Controller and Display Installation a Uživatelský manuál stáhnout pdf (Strana 54)

• WhenanOutBackHUBisemployed,theGENSTARTCONTROLonlyaectstheFX

programmedastheAGSPORTintheAGSsetup.isistheHUBPortconnectedtothe

FXwiththegeneratorstartrelay.

<OFF>manuallyoverridesAGSmode.Pressing<OFF>bringsupMAN-OFFindicatingthe

user manually shut o the generator.

<AUTO> allows the MATE to automatically start and stop the generator according to the

settingsprogrammedintheADVANCEDAGSmenu.Pressing<AUTO> brings up either

AUTO-OFForAUTO-ONdependingontheFXprogramming.

<ON>manuallyoverridesAGSmode.PressingitbringsupMAN-ONindicatingtheuser

manuallyturnedthegeneratorON)

<OK>ReturnstothepointinthemenusystemwhereyouenteredtheGENSTART

CONTROLscreen.

GEN START CONTROL

currently: MAN-OFF

OFF AUTO ON OK

PRESSTWICE:

• eGENSTARTCONTROLscreenallows

changes to the Advanced Generator Start

(AGS)mode.

• eAGSsettingsonlytakeeectwhen

Advanced Generator Startisenabled(Seethe

AGSModesectionformoreinformation).

NOTE:isdoesnotcontroltheGenAlert

function.

NOTE:ToresetanAGSerror,press<OFF> and then press <AUTO>.

PRESSTHREETIMES:

CHARGER CONTROL

currently: AUTO

OFF AUTO ON OK

• eCHARGERCONTROLscreenappears.

• isallowstheoperationoftheFXbattery

charger to be preset for an available AC source.

• WhenanOutBackHUBisemployed,the

CHARGERCONTROLonlyaectstheMaster

FXconnectedtoPORT1.eMasterFXthen

givesthesamecommandtoallslaveFXs.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 131 132

Žádné komentáře

Outback-power-systems MATE2 System Controller and Display Installation a Uživatelský manuál Strana 54