Outback-power-systems MATE2 System Controller and Display Installation a Uživatelský manuál stáhnout pdf (Strana 53)

AC INPUT CONTROL

currently: DROP-HBX

DROP USE OK

AC INPUT CONTROL

currently: USE-HBX

DROP USE OK

• eACINPUTCONTROLscreenis

called up, allowing the user to connect or

disconnecttheFXtoanACinputsource.

• IfaHUBisemployed,ACINPUT

CONTROLonlyaectstheMasterFX

connectedtoPORT1;theMasterFXthen

givesthesamecommandtotheSlaveFXs

AC INPUT CONTROL

currently: USE

DROP USE OK

<USE>enablestheFXtoconnecttoanACinputsource.

<DROP> disconnects the AC input source but will allow it to be reconnected if the “low

batterycut-osetpoint”occursortheFXisoverloaded.

<OK> returnstothepointinthemenusystembeforeyouenteredtheACINPUTCONTROL

menu cycle.

If HBX Mode is enabled, the AC INPUT CONTROL will read:

PRESSONCE:

INV

Hot

Key

AC IN Hot Key

e AC IN “hot” key allows direct control of the AC input from anywhere in the menu system.

e yellow LED indicator above the AC IN “hot” key has three settings:

• Flashing - an AC source is available, but not connected

• Continuously On - the AC source is connected and in use

• O - no AC source is present

enumberofACINkeypressesdetermineswhichmenuiscalledup.

MAIN--------------------------

1:35:04p

SUM STATUS SETUP ADV

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 131 132

Žádné komentáře

Outback-power-systems MATE2 System Controller and Display Installation a Uživatelský manuál Strana 53