Outback-power-systems MATE2M System Controller and Display Installation Uživatelský manuál stáhnout pdf (Strana 4)

1.0 Introduction

The OutBack MATE2M is a complete system controller and display for the OutBack FX inverter/charger. It provides a display

of the operation as well as allows for control and adjustment of the product setpoints. The OutBack MATE2M also coordinates

the operation of the entire inverter / charger system to maximize the performance and to prevent multiple products from

conflicting.

Through the use of an OutBack HUB communication manager a single OutBack MATE2M is able to connect to multiple FX

inverter/chargers and other OutBack products. A maximum of ten OutBack products will be able to be connected to a single

MATE2M via a HUB using CAT 5 type Ethernet cabling with 8 wire RJ45 modular connectors.

1.1 Features

INVERTER LED

INVERTER

BUTTON

FOUR “SOFT”

BUTTONS

4 by 20 character

backlit display

AC INPUT LED

AC INPUT

BUTTON

LCD Display

Four line, 80 character backlit LCD display with alphanumeric and graphic displays

Control Keypad

Six backlit silicone membrane keys – dedicated Inverter and AC input “hot” keys for control & 4 soft keys

Status Indicators

Two LED indicators: Green = Inverter status Yellow = AC Input status

Communication Protocol

Proprietary OutBack Multi-drop network using the OutBack HUB.

Interconnecting Cable

Standard CAT 5 PC network cable with RJ45 modular connectors / wired as non-crossover

Maximum Cable Length

The maximum distance that has been tested is 1000 feet of cable in an office / commercial building with success.

Optional PC computer interface

RS232 Opto-Isolated DB9 serial communication port

19009 62

Ave NE, Arlington WA 98223 USA

Page 4 Rev 1.00 03/31/04 Tel 360 435 6030 Fax 360 435 6019

1 2 3 4 5 6 7 8 9 ... 38 39

Žádné komentáře

Outback-power-systems MATE2M System Controller and Display Installation Uživatelský manuál Strana 4