Outback-power-systems FLEXware 250 - Users Guide Uživatelský manuál Strana 11

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 16
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 10
9
Installing the FLEXware 250
With the FX secured to a surface (see FX Series Inverter/Charger Installation Manual for details),
the FLEXware 250 installs on either the DC or the AC side of the FX.
To install the FLEXware 250:
Remove the cover plate screws and cover plate.
Verify which knockouts will be removed for the installation and remove those knockouts.
Remove only the two M5 X 12mm screws that secure the FX’s upper and lower casing
halves on whichever side (AC or DC) you rst install the FLEXware 250.
Insert the unthreaded standos into the holes on the FX and then insert two M5 X 25mm
screws, included with the FLEXware 250, into the standos and tighten.
After all wiring has been completed, install the DCC and securing with four M5 X 12mm
screws (included with the DCC).
Install each FLEXware 250 top cover plate and secure the #10 X 3/8” sheet metal screws.
For AC wiring instructions for the FLEXware 250, please see the schematics in the individual
AC Input/Output/Bypass Assembly (IOB) kits.
Figure 8: FLEXware 250 Dimensions
Zobrazit stránku 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Komentáře k této Příručce

Žádné komentáře