Outback-power-systems FLEXware 1000 Users Guide Uživatelský manuál stáhnout pdf (Strana 12)

When installing the AC chassis and the DC chassis:

• Either chassis can be installed rst, the order is not important.

• Only loosely install the eight screws securing each chassis. The screws will be tightened later.

To install the chassis:

• Hold each chassis up to its respective mounting holes on the FW-MP.

• Place the, M6 X 10mm machine screws through the chassis and into the holes shownin Figure 7

tightening only enough to keep the chassis in place.

AC side DC side

Figure 7: Chassis Mounting Holes

AC chassis

Mounting Holes

DC chassis

Mounting Holes

Figure 8: AC and DC Chassis mounted

With each chassis loosely mounted, the AC Conduit Adapter (ACA) and DC Conduit Adapter (DCA)

are installed on the FX.

• Remove the clear plastic AC cover and AC Conduit Plate from each FX.

Clear plastic AC cover

AC Conduit Plate

Figure 9: FX Series Inverter/Charger

DC Wiring

Cover (DCC)

1000 Manual.indd, Spread 12 of 12 - Pages (12, 13) 11/22/06 11:07 AM

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Žádné komentáře

Outback-power-systems FLEXware 1000 Users Guide Uživatelský manuál Strana 12