Outback Power Systems FLEXware 500 Uživatelský manuál stáhnout pdf (Strana 10)

After the FXs are installed, mount the AC chassis and the DC chassis in either order.

Note: It is easier to remove the

appropriate side knockouts

from both the AC and DC

chassis before installing either

of them. If needed, the back

knockouts must be removed

before installation.

Figure 6: Removing chassis

side knockouts

When installing the AC chassis and the DC chassis:

• Either chassis can be installed rst, the order is not important.

• Only loosely install the four screws securing each chassis. The screws will be tightened later.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Žádné komentáře

Outback Power Systems FLEXware 500 Uživatelský manuál Strana 10